This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| en:how_to_replace_sdp-1000_battery_pack [2019/02/17 22:16] – admin | en:how_to_replace_sdp-1000_battery_pack [2020/01/10 13:51] (current) – admin | ||
|---|---|---|---|
| Line 3: | Line 3: | ||
| <note important> | <note important> | ||
| **CAUTION** | **CAUTION** | ||
| - | * If the circumstances allow, ask the dealer for the replacement. | + | * If circumstances allow, ask your dealer for a replacement. |
| * Be careful not to overtighten the screws. | * Be careful not to overtighten the screws. | ||
| - | * Please recycle the used batteries | + | * Please recycle the used batteries |
| </ | </ | ||
| Line 19: | Line 19: | ||
| {{ : | {{ : | ||
| - | Carefully pry the battery packs off the back plate by using a tool such as straight razor. | + | Carefully pry the battery packs off the back plate using a tool such as a straight razor. |
| {{ : | {{ : | ||
| - | Remove residual | + | Remove residual |
| {{ : | {{ : | ||
| - | Remove peels of the tape from the new battery pack. And center | + | Remove peels of tape from the new battery pack. Center |
| {{ : | {{ : | ||
| Line 34: | Line 34: | ||
| {{ : | {{ : | ||
| - | Hold the new battery pack at the angle like th eimage | + | Hold the new battery pack at the angle like the image above, and plug the outer (battery) terminals in. |
| {{ : | {{ : | ||
| Screw the battery holder plate (outer four) screws in place, and make sure the foot is positioned in the lower and outside corner. | Screw the battery holder plate (outer four) screws in place, and make sure the foot is positioned in the lower and outside corner. | ||